Tool Room and Training Centre, Admission to PG Course in Tool Design and Manufacture PGTDM

Discussion in 'Mechanical Students' started by krishna, Sep 23, 2013.

  1. krishna

    krishna Banned

    Tool Room and Training Centre, TRTC, Delhi
    .
    Wazirpur Industrial Area
    Delhi
    Delhi
    Phone-No: 27372618 27372615 26383167
    Fax:
    Email: trtc@bol.net.in
    Website: ::::::DITE:::::::


    Course Name:
    PG Course in Tool Design and Manufacture PGTDM
    in Tool Room and Training Centre, TRTC, Delhi
    Course Description:
    Post Graduate Course in Tool Design and Manufacture
    Parttime:
    n
    Fee:
    .
    Eligibility:
    Eligibility and Selection Procedure for PG Course in Tool Design and Manufacture PGTDM in Tool Room and Training Centre, TRTC, Delhi
    Graduate in Mech. Or Prodn Engg or equivalent with 60% marks in aggregate (Pass in qualifying exam for industrial sponsored candidates).
    Age: Max. 27 years
    Mode of Test: Based on Entrance test (No. entrance test is required for industrial sponsored candidates and selection is based on the marks obtained in the qualifying exam)

    How To Apply:
    Application Procedure for PG Course in Tool Design and Manufacture PGTDM in Tool Room and Training Centre, TRTC, Delhi
    The prescribed application form & Prospectus can be obtained (or download from ::::::DITE:::::::) from the centre between 9:00 am & 3:00 pm on payment of Rs. 500/-, Rs. 125/- for SC/ST (non-refundable) as application & examination fee or by sending DD in favour of TRTC, Delhi. The reservation of seats shall be as per prescribed Govt. rules.

    No TA/DA will be admissible or attending the Entrance Examination. Course is to start on 4th week of February 2013 at Sub-Centre, TRTC, Okhla, New Delhi-110020

Share This Page